POM6
Thermal imaging measurements
Aims and scope of the test :
- We offer complex thermal imaging testing addressed to broadly defined industry. We perform the thermal imaging measurements using highest quality equipment, including FLIR SYSTEMS cameras that guarantee short time of scanning large surfaces.
Category
metrology
Symbol
POM6
Application
- Thermographic analysis of construction details focused on detecting delamination, fracture, discontinuity, porosity and voids in the tested material
- In-situ diagnostic tests using thermovision cameras (applicable to bearing nodes, gearbox, power hydraulics elements and other elements of drive systems)
- Quality control and technical condition assessment of the construction or connections in the construction, energy, automotive and heating industry
Photo gallery
Equipment
Table Equipment available for non-destructive testing using active thermography
| Type of testing | Load range | Testing conditions | Equipment |
|---|---|---|---|
| Thermovision camera for the composite testing system Thermovision inspection camera Halogen lamps |
We provide help with selecting the right conditions for tests; we can perform the full measurement cycle, record and process test results as well as prepare reports on the performed tests and analyses.
It is also possible to prepare reports focused on identifying the factors affecting the occurrence of failures of the tested systems and develop relevant corrective procedures.
Catalogues
We are available if you have any questions or concerns
regarding the accuracy of selected services
Contact person:
Jakub Słoniewski
jakub.sloniewski@emt-systems.pl
(32) 411 10 00
571 208 604
